50 x 2 Drum Sander

• Continuous-duty 7 1/2HP motor, 208-230 Volt power, single or 3 phase
• SandSmart automatic control of the infinite-variable feed rate of the conveyor (0-15 ft./min.)
• Precisely dimension stock within .010" across width of sander
• Magnetic starter
• Multiple grit sanding in single pass
• 50" wide dual (x2) drum sanding capacity
• Casters included, (wheel and swivel lock)
• Electric height adjustment, high speed and adjustable speed
• ProScale depth gauge (DRO), insures proper dimensioning
• Precision-flattened steel conveyor bed reinforced with four steel cross sections for no "flex"
• Self-cooling drum with abrasive Take-up Fasteners, make changing abrasives quick and easy and keeps abrasives tight
• Sand stock as short as 3-1/2" as thin as 1/32" and as thick as 12"
• Cast stand, zinc-platetd steel bed, centerless ground column tubes
• Minimum of 1800 CFM dust collection recommended
• Shipped assembled, some minimal assembly required
• Drum ball bearings are sealed and permanently lubricated
• 30 Amp Electrical service required on 3 phase, 50 Amp service required on single phase

Accessories: Rack-N-Roll (Abrasive Storage Shelf), "Pre-Marked" abrasives